Re-Pairing Cino F780BT scanner to Smart Cradle
02/07/15 07:55
To pair the BT scanner and the Smart Cradle, both of them should be set to “Uninstall” state...
To pair the BT scanner and the Smart Cradle, both of them should be set to “Uninstall” state.
Uninstall Scanner
To set the BT scanner to “uninstall” state, please scan the barcode below.
If this fails, please uncrew the end-cap of the scanner, unplug the battery and plug back the battery to do reset the scanner.
Uninstall Cradle
To set the Smart Cradle to “Uninstall” state, please press and hold the reset button (See “3” on the diagram below) for over 3 seconds until the LED indicator begins to display alternate red and green blinks.
Pair
To pair, scan the barcode below and then place the BT scanner on the Smart Cradle.
What does the LED indicator mean?
Uninstall Scanner
To set the BT scanner to “uninstall” state, please scan the barcode below.
If this fails, please uncrew the end-cap of the scanner, unplug the battery and plug back the battery to do reset the scanner.
Uninstall Cradle
To set the Smart Cradle to “Uninstall” state, please press and hold the reset button (See “3” on the diagram below) for over 3 seconds until the LED indicator begins to display alternate red and green blinks.
Pair
To pair, scan the barcode below and then place the BT scanner on the Smart Cradle.
What does the LED indicator mean?
| Cino BT scanner: | status |
| 1 blue blink per 2.5 sec: | Radio connected |
| Alternate red and green blinks: | “Uninstall” state |
| Smart Cradle: | status |
| Centre – steady blue; side – steady green: | Radio connected |
| Centre – off; side –steady red: | Radio disconnected |
| Alternate red and green blinks: | “Uninstall” state |